| MODEL | MAIN / PRE (YFE-370, 320) |
| Structure and Materials | ใ |
| maintenance | Use mild detergent |
| Filter | Removal solid body over 40ใ, 5ใ(100%) |
| Materials | Sintered resin |
| Installation Site | MAIN LINE/ Refrigerated Air Dryer or Filter(YFE-310, 130, 150) be installed in front.. It should be used for Preventing condensate flows. |
| Repair and replacement | Element should be cleaned, when foreclosure is 0.7ใ/ใ .. and the mild detergent and gasoline, paint thinner should not be used |
| MODEL | LINE (YFE-310) |
| Structure and Materials | ใ |
| maintenance | Cartridges exchange |
| Filter | Removal solid body over 1ใ(100%) |
| Materials | HEPA |
| Installation Site | Installed in the pipe end portion or desiccant dryer, Filter (YFE-130, 150) be installed in front, in order to extend the life cycle of the advanced filter |
| Repair and replacement | When the differential pressure 0.5ใ / ใ over, disassemble the filter and replace the cartridge in the filter with a new one |
| MODEL | COALESCENT (YFE-130) |
| Structure and Materials | ใ |
| maintenance | Cartridges exchange |
| Filter | Removal solid body over 0.01ใ(100%) |
| Materials | HEPA / Polyester |
| Installation Site | Install in area of oil and moisture to be removed, if you set up in front of desiccant dryer, increase the absorbent life. |
| Repair and replacement | When the differential pressure 0.5ใ / ใ over, disassemble the filter and replace the cartridge in the filter with a new one |
| MODEL | ADSORBENT (YFE-150) |
| Structure and Materials | ใ |
| maintenance | Cartridges exchange |
| Filter | Removal solid body over 0.001ใ(100%) |
| Materials | HEPA / Polyester / Activated carbon paper |
| Installation Site | As a filter for installation in the final end of the pipe line to remove the solid matter than 0.001ppm, install a site of clean compressed air needed. |
| Repair and replacement | When the differential pressure 0.5ใ / ใ over, disassemble the filter and replace the cartridge in the filter with a new one |
